Build your strata budget.
Plan for the big jobs.
Add up a year of everyday costs, list the major works you can see coming, and check whether your capital works fund will cover them. This free calculator uses your own figures to draft the year’s contributions and a 10-year funding check.
Free, with no account needed. See your figures in the calculator and get the PDF report by email. Have last year’s budget, recent bills and any quotes for major work handy.
Start with the building.
Enter the number of lots and the year the budget starts. Last year’s budget or levy notice shows what owners pay now.
What goes into a strata budget?
A NSW owners corporation budgets for two funds each year, and owners’ levies pay into both. The calculator follows the same three parts as the budget wizard in SimpliStrata.
- 01 / Administrative fund
The everyday costs of a normal year.Insurance, common water and power, cleaning, small repairs, inspections and administration. Start from last year’s bills and replace estimates with contracts and renewal quotes.
- 02 / Capital works fund
Saving for the big jobs.Painting, roofing, waterproofing and replacing shared equipment. List each job with a cost in today’s dollars and the year you expect to pay for it.
- 03 / The 10-year check
One contribution, tested against ten years.Each year starts with the last balance, adds the contribution and pays for the work due. A balance below zero means the fund runs out before the work is paid for.
NSW Government guidance: strata finances and insurance, levies and the 10-year capital works fund plan.
A draft is where
the work starts.
What owners still decide
The budget and the levies are decided by owners at a general meeting. This estimate is something to bring to that conversation, with the bills and quotes behind each figure.
What SimpliStrata adds
In SimpliStrata the same wizard starts from your scheme’s own bills and fund balances, splits contributions by unit entitlement, prepares the 10-year plan paper and carries the budget into the meeting and the levy notices.
A few useful details.
How much should we put into the capital works fund?
It depends on the work your building needs and when. The calculator works out the lowest constant yearly contribution that pays for the works you enter as they fall due. It is a planning result based on your figures. It is not a minimum set by law, and we do not publish a benchmark per lot.
Does this replace our 10-year capital works fund plan?
No. NSW publishes a form for the 10-year capital works fund plan, and your scheme’s plan is a separate document owners consider. Use this calculator to test figures before the plan is prepared or reviewed. See the NSW Government page on the plan.
Is the per-lot figure my levy?
Only if you add unit entitlements. Levies are shared by unit entitlement, so lots in the same building often pay different amounts. Without entitlements, the calculator shows a simple average per lot for comparison.
How are future costs estimated?
You enter each major work in today’s dollars. The calculator increases it by your annual percentage for every year after the first, and rounds to the dollar. Interest earned on the fund and tax are left out. A current quote or a quantity surveyor’s estimate is better than any percentage.
What if the fund runs short?
The calculator shows the first year the balance falls below zero and the contribution that would avoid it. Check the opening balance, quotes and timing first. Owners then decide how to fund the work at a general meeting. See the NSW Government guidance on levies.
What happens to the figures I enter?
Calculations happen in your browser, and entries are not kept after a refresh. When you request the PDF, your figures, building details and the contact details you provide are sent to SimpliStrata to prepare and email the report. You can include up to five other owners or committee members as BCC recipients. They receive the report only. Marketing updates are optional for you and are not enabled for additional recipients. Read about privacy.